680zz bearing windmill, 19mm broomstick windmill, handheld windmill

Non-printed components:

1, 608zz bearings, approximately 0.5 RMB each will suffice. Inexpensive ones may be noisy, while more expensive ones are unnecessary;

Alternatively, you can purchase official 608zz bearings from this link

2, 19mm outer diameter threaded stainless steel broom handle, approximately 1.5 RMB each, should be available for under 2 RMB. Purchase ones with pre-existing threads; avoid those requiring additional plastic components.

Assembly instructions:

1, Remove supports

2, Insert bearings into the windmill blades, ensuring correct orientation (alternating directions). Install the first windmill blade, as shown below:

3, Install the second windmill blade, minding the groove orientation

4, Install the broom handle, taking care not to cross-thread.

5, Install the base cover to prevent injury from the sharp end of the stainless steel tube. Complete

Thanks to Brent Peterson for the propeller customization generator