Knipex Pliers Holder Ikea Skadis

Knipex Pliers Holder for an Ikea Skadis Pegboard

Update! The models were equipped with more hooks for hanging to better distribute the load and prevent the hooks from breaking

There are two different holders, one version is for small electronics pliers (115 or 125mm) and one version for medium-sized electrician pliers such as side cutters or combination pliers with a length of approx 140mm. One holder accommodates a different number of pliers, depending on how large or wide the pliers are. The holders certainly also work with pliers from other manufacturers, but I have only tried them with Knipex pliers. Any number of holders can be arranged directly next to each other or with some distance one above the other. For easy removal and to optimize space on the pegboard, the receptacles are arranged at a 45-degree angle. In addition, there is a small storage compartment at the back of the holder to make good use of the necessary clearance

The model can be printed with different materials, minimal support is necessary. Due to the geometry of the model, it may tend to warp slightly at the beginning of the print, so good bed adhesion must be ensured. A 5mm brim is already provided, increasing the bed temperature by 5-10 degrees can also be helpful

Also check out my other models for the Ikea Skadis pegboard:

Screwdriver Holder Ikea Skadis

Screwdriver Bit Holder Ikea Skadis

Makita 18V Battery Holder Ikea Skadis

Drill Bit Holder 1-13mm Ikea Skadis

Battery Holder and Dispenser Ikea Skadis

Customizable Universal Holder Ikea Skadis

Crimping Pliers Holder Ikea Skadis

You don't have an Ikea pegboard but a Küpper or Element System one? I have also created suitable holders for those

Happy printing!