Baguette Bag - Paris Fashion Week

My last profile got taken down because I couldn't get a successful print of this in one shot and just uploaded renderings. After three attempts I managed to get it to print now so here is the new profile with the print settings. It is important to use minimal layer height due to the overhangs. I was toying with modeling in embedded supports, but this attempt finally worked. The photo of the model is after I have already post processed it with sanding an a thick coat of duplicolor filler primer to mask the layer lines.  

You can attempt to split this and glue it together for cleaner curves. My one warning for that is to ensure that you mark the orientation with w sharpie on the parts before you take it off the print bed. My attempt at doing that left me with a mangled sculpture in the end because aligning the pieces perfectly is nearly impossible.