Search models, users, collections, and posts
USB Memory Stick Storage Box Extended
Remixed by
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 10% infill
Designer
3.5 h
2 plates
Open in Bambu Studio
Boost
78
289
21
5
529
276
Released
Description
The original version of this (which I have also printed) wasn't big enough for all my USB sticks and adaptors. So I've modified the design to remove the original Micro/SD card slots and just have an empty box which exactly matches the dimensions of the card holding box I already have!
If you use 6x m2x16mm screws they should bite through the plastic nicely, in my case I have used filament so needed to drill out the holes a fraction (2mm) which is now slightly oversize, that said friction/tension holds it all together fine for something that lives in my desk drawer but you may like to add a drop of glue if you use this method.
Enjoy.
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (21)