Search models, users, collections, and posts
Drift wheels for Himoto HI2101
IP Report
Print Profile(0)
Add the first print profile to earn points
Boost
5
8
0
0
9
3
Released
Description
It was designed for a Himoto HI2101, which uses a 12mm (inscribed) diameter hex nut and an M3 bolt for fastening. May fit other rc cars too, i only had this one on hand.
You can put supports in the hole in the center for better surface quality, but can be printed without them too if you don't care about that. Print with 3 perimeters for strength.
They are quite durable, I have crashed the car many times with these wheels and none of them broke so far. Not even the ones made of PLA.
License
This user content is licensed under a
Creative Commons Attribution
Comment & Rating (0)