【T恤上的3D打印】Long neck birds

Finally, I completed the self-designed accessories for p/x series T-shirt printing, and my recent attempts have been very successful. I tested both P1S and X1C, and there was no issue.

I tried printing 0.4mm (0.2mm layer, 2 layers in total), and printing 0.2mm (0.2mm layer, 1 layer in total). The effect of printing one layer on a pure white cotton T-shirt is good enough. 0.2mm of PLA is soft, it did not affect the softness of the T-shirt itself, it can still be kneaded, pulled, and cleaned in a washing machine without any problem.
I have tested dots patterns and hollow line patterns, and there is no problem with them.

Some key notes:
1. Turn on automatic leveling,
2. After starting, please quickly adjust the heating bed temperature to 30 degrees Celsius,
3. Please close the prime tower,
4. Please do not print large area patterns or any patterns with excessive thickness (like more than 1mm).

In this hollowed out line drawing, I used the key chain generator in MakerLab, but the model did not fully meet my requirements. After I exported it, I modified the model, deleted some redundant objects, and then adjusted the thickness. If you will also use this tool, please be cautious. I must also admit that using this MakerLab tool to generate multi-color 3D models is indeed very convenient.

I will share this accessory in the near future. Due to the size of it, the P/X series cannot print this accessory directly. Therefore, I need to make split it as several parts. Please be patient and wait a few more days.