Batman DawnBreaker Textured Helmet
Print Profile(1)
Bill of Materials
Description
Batman DawnBreaker Helmet
Translucent Green PLA can be used for the Lens if you want a translucent green look.
This filament was added to the BOM incase you wanted to go that route and Is absolutely NOT necessary.
Sized to fit my number 3 sizing head found here - https://makerworld.com/en/models/525268
Uses 6x2mm and 5x2mm Magnets, - Be sure to use the magnets in the BOM as they were tested and work properly.
Magnets in total for the build - 6x2mm =12 in total - 5x2mm = 28 in total
Use Super Glue "I use the gel kind" when inserting the Magnets, Jaw, and Lens.
The inside of the helmet may look a little low poly before slicing and that's because it is.
To get the texture to look right on the outside somewhere had to take a bit of beating. This does not effect the model after slicing, as you can see in the Pictures.
Enjoy
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (25)