Retro Propeller Fighter Plane (pre-plated, Articulated)

This model masterfully blends the characteristics of a vintage propeller plane with cyberpunk elements, adorning the wings with an array of weaponry. Twin rotary cannons, two smaller machine guns, a central large cannon, and two rockets beneath each wing flank two aerial bombs suspended from the fuselage. A truly impressive arsenal.

The model measures 154x161x71 millimeters. The propeller and wheels are rotatable.

Tools required:

1. Glue
2. Needlenose pliers
3. Tweezers

Important Notes: (Please read carefully!)

• This model has been extensively tested and prints without issue, however, assembly requires patience and skill—this is part of the charm of assembling models (not recommended for the impatient);
• One side of the front landing gear includes an axle; exercise caution when removing supports to avoid breakage;
• If the cockpit proves difficult to insert, carefully use needlenose pliers to trim the bottom, creating a 45-degree bevel on the edges (only use this method if installation is problematic);
• Install the wing rockets last. Gently secure the glued rockets and allow the adhesive to set naturally;
• Assemble the model sequentially according to the assembly instructions. Some parts may be tight; adjust the part surfaces as needed;
• Clean the build plate before printing and calibrate filament flow in high temperatures;
• This model contains numerous small parts and requires glue for assembly, as indicated in the assembly manual;