Wall/desk clock café racer

https://makerworld.com/en/collections/4639439-licensed-models

You can sell this model and all models in the above link with a Patreon membership.
www.patreon.com/cP_3D

Be sure to visit my profile page to find more great models!
https://makerworld.com/en/@cP3D

I have made another clock here. Perhaps some of you will also like this clock.
I could imagine that this clock would also be a very nice gift for someone.

I have created a 170mm and a 245mm version for wall and table

If you would like to enthuse others about these wall clocks, please share the link on social media.

Here you will only find the clock faces!
The necessary accessories can be found under the following link:

https://makerworld.com/en/collections/4894074

To minimize print time without compromising quality, I have configured height range modifiers in my print profiles. So don't be surprised if the swap commands do not match the data in the print profile

Print at 100% infill with a layer height of 0.06mm with a base layer of 0.12mm

Swap Instructions:
    Start with Black
    At layer #19 (1.2mm) swap to Jade White for the rest.

If you get the message with the floating regions when slicing... you can ignore it
 

Here you will find my other clock faces collected
https://makerworld.com/en/collections/1715414