H2D H2S Under Desk Build Plate Holder 5,*7,10

Use this model if you just want an H2C version: H2C Under Desk Plate Holder by Ulade MakerWorld: Download Free 3D Models

Print V4.3 5+2 if you want special slots for the vision encoder, cutting matt-style plates.

Print H2 Series Under Desk Plate Holder if you just want to hold your H2D/S plates. The vision encoder and cutting mat also fit in this with just more side tolerance.

This is a high-capacity under-desk plate holder designed for the H2D/S. See my link below if you want a specific H2C model, though the plates will fit this model. It keeps your build plates protected, easy to reach, and off your work surface. The design prints in one piece on all H-Series printers and mounts cleanly under a bench, table, or desk.

Large print for H2D - a little over 12.5 hours of print time for the 5-plate version.

Holds 5, *7, or 10 plates (Big Thank You to @MPlessl for testing and tweaking a solid 10 plate print profile in ASA)

Designed to be mounted under a bench, table, desk, or on a wall/side mount

The 7 plate version holds 5 print plates and has two slightly smaller slots designed for the vision encoder and cutting plate

• Fast swaps during multi-plate projects
• Plates stay aligned so surfaces do not rub
• Slim profile to save space under the mount
• Six mounting points for a solid feel
• Five slot body and ten slot body
• Sized for stock Bambu H2 series plates. 

Designed for the H2 series community. Real-world feedback is welcome, so this holder can keep getting better for everyone.

If you print this, please consider leaving a rating and sharing a photo in the comments along with any fit notes from your setup.

Recommend #12/M5 wood screws, ¾" - 1" | 20mm - 30mm.

Mounting

Option one use wood or self-tapping screws for a permanent mount

There are 4 recessed mounting holes.

I recommend using all 4 corner holes but any combination of 3 will work well. Don't overtighten the screws, they just need to be snug.

Steps
-Hold the rack where you want it and mark the holes
-Drill pilots if needed
-Level the rack, drive the screws, and snug them without overtightening

Option two use double sided foam tape 

The plate holder can be mounted under a desk, table, bench, on a wall, or the side of a bench. My pictures show both of my mounts one under a small wood table I use for my H2D and one on the side of the table's legs. I used screws for both of these mounts as I plan for them to stay permanently. The side mount is only using 2 screws in the two front holes and is holding up very well.

A1-MINI version: Under Desk Plate Holder - A1 Mini by Ulade MakerWorld: Download Free 3D Models

Looking for the X/P/A1 version: Under Desk Plate Holder P1 X1 A1 3 5 7 Slots by Ulade MakerWorld: Download Free 3D Models

H2C: H2C Under Desk Plate Holder by Ulade MakerWorld: Download Free 3D Models

Like this model? See my other H2 Series Under Desk models:  UnderDesk XL 7x7 Gridfinity Expandable Drawers H2D by Ulade MakerWorld: Download Free 3D Models