Search models, users, collections, and posts
Exhaust Hose Cap for XTool S1 (85mm)
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
55 min
1 plate
Open in Bambu Studio
Boost
17
62
4
1
77
35
Released
Description
A practical screw-on cap for the 85mm exhaust hose of the XTool S1 laser cutter. Simply screw on when the device is not in use.
Why use a cap?
Better air quality: Prevents residual odors and fumes from escaping through the open hose into your workspace when the laser is idle.
Hose protection: Keeps the hose end free from dirt and damage that could later affect the seal performance.
Hygiene: Prevents microorganisms from settling in the idle hose or insects from entering.
Easy handling: Thanks to the threaded design, it's quick to screw on and off without removing the hose.
The cap prints perfectly with any layer height from 0.08mm (high quality) to 0.20mm and requires no support structures!
License
This user content is licensed under a
Creative Commons Attribution-Share Alike
Comment & Rating (4)