Strap'it'up - Guitar strap snap-fit lock
Print Profile(2)
Description
Strap-it-ip is a sturdy, snap-fit quick-release system for your guitar strap — bringing speed & strength to your gear!
Built as click-and-go parts, it locks securely and won't let you (or your guitar) down!
Whether you’re mid-gig, mid-jam, or mid-chaos - this little buddy gets your strap off in seconds.
Fits standard strap button (14 mm) and most common strap widths - 50 mm, 40 mm, 30 mm, 25 mm .
Indicated print time is for ALL the variants, typically a set of 2 buckles is printed in less than 1 hour.
⚙️ Notes:
- Fully mechanical, no screws, bolts or glue
- Prints nicely in PLA or PETG (tolerances tested & approved for both)
- Print profiles include variable wall counts for different parts, to balance strength for the buckle & flexibility for the snap-on part.
- Minimal supports are required to print buckle horizontally, giving it more structural strength (vertical models snap along the printing lines). I know they can be harsh to remove, I minimised them as much as possible, but your gear was too precious to me to compromise on strength, so bear with me on this one.
Boost Me (for free)
🚀 Give me that little extra boost to help me develop further useful stuff for free ! 🚀
> Check my other creations here 👀 , over 25.000 cumulated prints & downloads can't be fully wrong 😉 🙏
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (2)