Search models, users, collections, and posts
Simplehuman Trash Can Spacer 13Gal
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
51 min
1 plate
Open in Bambu Studio
Boost
22
52
17
6
86
57
Released
Description
Spacer to keep from rubbing the paint off the wall. Thin to try an minimize how much offset it had front to back and as wide as the plate to try and keep it from wobbling side to side. Also added 2 lips to try and hold it in place instead of double sided tape. Print and drop it in. I used Gray Bamboo Matte PLA.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (17)