Air conditioner deflector

DESCRIPTION:

Air conditioner deflector designed to redirect airflow in a domestic environment.

MATERIAL:

The use of PETG or other heat-resistant materials is recommended.
PLA and PLA+ may deform if exposed to hot air for prolonged periods.

ASSEMBLY:

The parts must be joined by plastic welding or gluing.

• For welding: use a fine-tipped soldering iron to slightly melt the contact surfaces (only for compatible materials such as PETG or similar).
• For gluing: use cyanoacrylate glue (superglue) or epoxy adhesive for greater strength.

It is recommended to:

• clean and, if possible, lightly sand the surfaces before joining
• maintain pressure during drying/gluing

The object's resistance strongly depends on the quality of the assembly, as well as the type and quality of the material used. Check for tightness before use.

INSTALLATION:

Ensure the deflector is securely fastened before use.
Periodically check the stability of the mounting.

LIMITS OF USE:

This model is designed exclusively for airflow deflection.
Do not use for supporting loads or for applications other than those intended.

Do not install above passageways or where falling could cause damage to people or objects.

Do not use in critical applications or where a potential failure could cause harm to people or property.

VERIFICATION:

Test the component after assembly before continuous use.

DISCLAIMER:

This model is an unofficial project, created for functional purposes and shared for free. Effectiveness and safety depend on print quality, the type of material used, and correct assembly.

The deflector has not been tested on all air conditioner models, nor under prolonged use conditions with hot air.
The author assumes no responsibility for any damages, malfunctions, or improper uses.

The user is responsible for verifying the suitability of the model for their specific use.
Use with care and common sense.