Death Star Lamp - Ikea Fado 17cm

The old model was unfortunately removed by BambuLab, the exact reason for this did not want to be mentioned clearly.

I am therefore uploading the relatively polar model again. I hope you enjoy it.

This is a remix of a model for the large IKEA Fado lamp (25cm). 

This adapted model is compatible with the IKEA Fado lamp (17cm). I had printed a moon in the same size and thought that a Death Star could look damn good too ;)

Here is the link to the IKEA product (FADO 17cm):
https://www.ikea.com/de/en/p/fado-table-lamp-white-40455437/

Please note that the ring around the launcher may not be perfect and some of the light may shine through a little more. This does not ruin the look at all and can be improved by slightly optimizing the print profile. 

In principle, no support structures are necessary. It worked very well without. However, if you want to be on the safe side, you are welcome to add supports.

Please post your results in the comments, I look forward to seeing your prints.
And now: Have fun printing.