The Brick Grip (phone grip/holder)

The Brick Grip! 

Easily adjustable multipurpose phone holder / grip. 

• Suitable for every smartphone: (from 5.5" screen size to 7"). The jaw can be adjusted from ~70mm to ~90mm. 
  (smaller phones can be used if you put a bit thicker rubber pads onto the jaws
• Easy adjustment: simple turning mechanism easily clamps your phone into the holder 
• Multi-purpose design: Can be used without the handle as a simple photo grip, or as a phone desk stand

Print placement for the strongest possible result

If you have trouble removing the support, use a side cutter to break from the bottom

Important:

Make sure your print bed is clean, and check your printer calibration. 

Verify the recommended settings, and make sure your bed is level. 

All parts are oriented for the best results. Brim and supports (if the part has any) have been adjusted to ensure successful printing.

Thank you.