65/75mm Motor Screw Dampers - Ultralight Bent Version

Previous Version was prone to breakage due to interlayer weakness in 3D printing, so a new version was created referencing the head cover's bending design. Testing shows excellent shock absorption and extreme lightweight (<0.1g).

Highly suitable for novice pilots on hard surfaces (especially indoors) to protect against crashes. When a drone crashes on the ground, it's the motor screws that directly impact, resulting in a very large instantaneous shock (I broke motor wires three times this way). Adding these dampers significantly reduces the likelihood of such incidents.

During installation, ensure you fit the single-hole side first, then bend 180 degrees to fit the remaining two screws. Because the design is exceptionally thin, avoid over-tightening; slightly back off to reduce twisting deformation.