Sovol SH02 & SpacePi X4 desiccant drying tray

This is a remix based on the Sovol SH02 Desiccant Drying Tray V2. I didn't like how it sat in the Sovol SH02 and would slide/fall down because it wasn't quite long enough. So I made it a little bit longer and wider. With the current size, it also fits in the new Creality SpacePi X4 dual bay heater. 

The current profile uses Bambu ABS-GF, with supports and a10mm brim as you can see in some of the pictures. When using regular Bambu petg-hf or Bambu Petg translucent, I have been turning off the brim and it prints just fine. I have found that using Petg-HF likes to get a little brittle when drying PETG at 65c for longer periods of time; but when using Petg translucent it's fine. Remember petg hf is rated at 69c heat deflection while Petg translucent is 74c.

Any questions just ask.