Indoor Boomerang v2

About v2:

    This is my last revision of my indoor boomerang. This time, it doesn't need an AMS (shorter print time too). Aerodynamics have been improved. The surface is now largely a continuous curve without as many obstructions. Weight has also been redistributed to the tips of the wings to make the boomerang spin easier/better. I know some people had issues printing the previous indoor boomerang. I improved the print profiles across printers and fine-tuned some settings.

    This model was created for right-handed people, but it can be mirrored in your slicer if you are left-handed. To throw, hold it nearly vertically and throw. You don't have to throw hard - just try to make the boomerang spin in the air (you can look up boomerang-throwing tutorial videos - this boomerang takes quite a bit of trial-and-error). The boomerang flies a few feet and comes back to you. I tried to design it so that it can be used in even the smallest rooms (but probably not your closet). It is very light, so it most likely won't cause any damage to objects it hits (but no guarantees).

Printing:

    This model is very thin. Your printer must be calibrated well.  If you have problems, feel free to post a picture of your print and I'll try to help.

Post Printing:

    Let the print bed cool completely before removing. After printing, bend the edge of each wing download along the dashed fold line and its TIME TO FLY!

Donations and commercial licenses (for most models) available here: https://www.patreon.com/TheLaughingCatCreations