Search models, users, collections, and posts
Sanding block with grip
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
2.7 h
1 plate
Open in Bambu Studio
Boost
4
11
0
0
4
2
Released
Description
Content has been automatically translated.
ATTENTION!!
I already made a second version that uses magnets instead of screws: https://makerworld.com/en/models/2757728-sanding-block-with-grip-v2#profileId-3060928
Based on printed sanding blocks, this one is similar but has a grip for screwdriver-like use
It uses sanding paper of your preference, which is held in place by pressure from the grip
It requires two screws around 4/4.5 mm wide
It is advisable to drill the screw holes if the supports do not come out easily
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)