Search models, users, collections, and posts
GoPro Hero Rugged Hard Case
Remixed by
IP Report
Print Profile(4)
0.2mm layer, 2 walls, 15% infill
3 h
3 plates
0.2mm layer, 3 walls, 15% infill
2.2 h
1 plate
Faster print, 2 plates - 0.2mm layer, 2 walls, 10% infill
3 h
2 plates
TPU Lid Insert, TPU Bottom Insert, Thicker TPU Gasket
5.2 h
2 plates
Open in Bambu Studio
Boost
634
1648
100
38
1.6 k
688
Released
Description
This is a simple rugged hard case for the GoPro Hero 12 action camera. Although designed for the Hero 12, others have said this works for the Hero 9 as well. It may fit other mdoels as well. It is designed to fit the bare camera without any camera case or screen protector.
- The design uses M3x20 screws
- Insert a thin foam pad in the top lid to prevent the camera from moving up and down in the case.
- Use glue or thin double sided tape to hold the insert to the bottom case in place if it is too loose and comes out when you take the camera out.
Recommended print settings
Layer height: 0.2
Wall loops: 3
Infill: 20% gyroid
Support: none
Elephant foot compensation: 0.3
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (100)