Search models, users, collections, and posts
Filament Guide for CR-6 SE
Remixed by
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
56 min
1 plate
Open in Bambu Studio
Boost
4
9
3
0
24
2
Released
Description
This remix was made so the roller would better line up with the runout sensor on a CR-6 SE printer.
You will also need two M5 x 30 screws to mount it to the frame, and one M4 x 25 to attach the roller. Edit: New roller design.
It was printed with CC3D PLA+ Yellow 1.75mm
Layer Height: 0.2
Perimeters: 2
Top and Bottom Layers: 3
InFill: 15% Grid
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (3)