Hose and assembly holder for extension coupler

I have finally solved a problem I have had since we bought our house in 2011. The problem has been that I almost never knew where I had my extension couplers for our water hoses when I needed them (they have been everywhere except in the right place). But now it has finally been solved with two solutions, a model for having an extension coupler on the hose and a model where you can screw it on where you need it. I have searched around the internet without finding any solution, so this is my 100% own design.

Attention! Please have in mind that there are very, very many brands for hoses and connections around the world, so it can be that this extension coupler holders not will fit. I have tried the models on four different brands and have came to a solution that works for those and hopefully for the one you got. 

If you print and it doesn't fit, don't give me a bad rating, instead write a comment or PM 

with your measurements and I'll do my best to make one that fits.

Good to know

• It is more or less a must to cut off a small piece of your hose (1-2 cm) to mount the extension coupler holder on the hose.
• Your extension coupling holder must not be wider than 34 mm.
• The outer diameter of the hose is a maximum of 17 mm.
• Use ABS filament for things that will be used outdoors.

If you've read all the way here, I'm probably not the only one who always has to look for my extension couplers. Glad I'm not alone. ;)

I really appreciate it when you rate my models and share photos, so please do so if you want! And if you think my model deserves a boost, I'll be happy. 

Check my profile for my other projects if you are interested.

@Henrik_Sweden

Please follow me so you don't miss anything new.