Skadis stand - Free 3D Print Model

Search models, users, collections, and posts

Remixed by

CMLab

Hobby & DIY>Other Hobby & DIY

IP Report

Print Profile(4)

All

P1S

P1P

X1 Carbon

X1E

A1 mini

H2D

H2D Pro

H2S

P2S

H2C

X2D

A2L

0.2mm layer, 6 walls, 25% infill +8 mm brim

1.6 h

1 plate

4.9(252)

A Pair, More strength Same Filament, 3 walls 7% infill

1.4 h

1 plate

4.9(51)

Small feet version

51 min

1 plate

4.8(17)

Version for rear mounting to desk tops

1.1 h

1 plate

5.0(1)

Open in Bambu Studio

Boost

1156

3862

354

129

4.8 k

2.9 k

Released

Description

Ho voluto modificare questo skadis stand per motivi di spazio, mi serviva poter mettere lo skadis molto vicino il muro sulla scrivania, quindi con fusion ho tolto parte del piede posteriore cosi da potermi avvicinare al bordo quindi più vicino al muro, la stabilità non cambia, nel caso serve più stabilità si può optare per del biadesivo 3M.

Comment & Rating (354)

@palancana

Print Profile

0.2mm layer, 6 walls, 25% infill +8 mm brim

I build a super nice spice rack with Skadis and I glued it on my kitchen. It was a nice idea, until 3 months later, it decided to go rogue, fell, and smashed a couple of spice glass bottles on the floor. After cleaning turmeric for what seemed like too long, I thought that maybe the weight should be better off standing on the feet. And this is by far the best model. It holds sturdy and fits amazingly. Now my Skadis spice rack is holding on the counter AND glued on the top for extra stiffness. I love this solution, if I get any boosts I'll send them your way. Thank you!

@eberlein.nico

Print Profile

0.2mm layer, 6 walls, 25% infill +8 mm brim

good quality with a solid design it also printed perfect with a nice finish. i printed 4 because of the hevy load on my board.

@L_MoSa

Does it support the weight with only the legs? Does the top part stay up without falling down?

Show original

@eberlein.nico

I connected it in the middle with the top using cable ties and therefore rather do not advocate the top

(Edited)

Show original

@ElRobotX

Print Profile

Small feet version

Perfect. I appreciate that I can fit yet more printed stuff on the shelf!

@Ligeiros

Print Profile

0.2mm layer, 6 walls, 25% infill +8 mm brim

good start to the project

Show original

@pedrote

Print Profile

0.2mm layer, 6 walls, 25% infill +8 mm brim

perfecto

@otcs

Print Profile

0.2mm layer, 6 walls, 25% infill +8 mm brim

printed two at once and no prob at all. surprised how sturdy it is. great job

@PigeonPrints

Print Profile

0.2mm layer, 6 walls, 25% infill +8 mm brim

These stands work exactly as intended! I printed with PETG and they feel quite sturdy. I also combined this print with the corner stand remix. Thank you so much for sharing this model!