Search models, users, collections, and posts
Cup holder block perch for an accipiter
IP Report
Print Profile(1)
0.28mm layer, 2 walls, 15% infill
Designer
11.8 h
1 plate
Open in Bambu Studio
Boost
3
3
0
1
11
1
Released
Description
Base has a hole on the bottom for a 3/8 driver so you can fill it with sand, rocks, ego, ect to make it weighted.
Measurements are 200mm high (7.87") and the top is 125mm in diameter (Almost 5") with a 5mm recess for astro turf. Print in PETG.
There is no leash tie off. If you want one, add a negative modifier in the slicing tool.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)