Roman Candle Holder

**Edit 6-30-25** I added an over-the-top handle and a different shaft with a 10mm hex to work with a handheld drill. Just keep the speeds down! The handle will need to be glued on to the main cylinder.

A quick model I put together to mimic a roman candle holder I saw in the fireworks stand, which was too expensive for me.

I did use Austingeorge's gear generator, found here: https://www.thingiverse.com/thing:1359815/files

The gears can be a little sticky at first, just give them a little wiggle and they should rotate freely.

Make sure you have the front and rear gear assemblies lined up before inserting.

Designed to use five roman candles at a time. the ones I bought from the store were about 16.5mm diameter.

Always be sure to follow manufacturer's instructions for fireworks, and use them safely. Use this at your own risk. It has not been tested. Keep the rotation speed low, and keep this pointed in a safe direction.

This is not a firearm, and is not intended to be converted into a firearm.