Toyota Sienna Center Console Black Hole Blocker
Print Profile(2)
Description
☕ ☕ Buy Me A Coffee! ☕ ☕ … Every coffee helps fuel new ideas. Thank you for your support!
Boost Me (for free)
Thank you for your support! Any comments / boosts are greatly appreciated!
Designed this “black hole blocker” to prevent items being lost into the black abyss when the lid is opened. If you are here, then you probably already know that the Toyota Sienna (2021-25) has an issue with the center console, making it near impossible (or at least not very easy) to get anything that slips below the glove box when the lid slides open.
The design is simple, it creates a ledge that acts as a blocker to prevent most items from being lost. I added a 1mm recessed pocket for double-stick tape (0.75" / 18mm width) to be added to the bottom for easy installation.
Print Profile for Sienna_BlackHoleBlocker_PLA
- Material: PLA is not ideal for high temperatures inside a vehicle, I would recommend using something else like PETG.
- Print Time: Prints WITH supports in about 1.5 hours and uses about 36g of filament in total.
Print Profile for Sienna_BlackHoleBlocker_PETG
- Material: Better suited for high temperatures inside a vehicle.
- Print Time: Prints WITH supports in about 1.5 hours and uses about 36g of filament in total.
☕ ☕ Buy Me A Coffee! ☕ ☕ … Every coffee helps fuel new ideas. Thank you for your support!
Boost Me (for free)
Thank you for your support! Any comments / boosts are greatly appreciated!
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (9)