Search models, users, collections, and posts
Shapton 210x70x10+15mm sharpening stone holder
Remixed by
IP Report
Print Profile(3)
10mm Version - 0.6mm, 0.3mm layer, 2 walls, 15% infill
Designer
3 h
1 plate
15mm version - 0.6mm, 0.24mm layer, 2 walls, 15% infill
Designer
3.3 h
1 plate
+1.5mm Increased height angles
Designer
2 h
1 plate
Open in Bambu Studio
Boost
75
225
13
1
257
142
Released
Description
Two printprofiles, one for 10mm and one for 15mm Shapton stones incl 4 angle guides in each profile.
I added an extra profile with increased clearance for the angles. Still same angles, but should fix issue a user had where the stones were hitting the bottom of the angles.
The angles included are 15, 17, 20 and 25degrees.
Recommend printing in PETG so it runs smoother. Else a bit of sanding might and/or some lubricant in the rails should do.
Thank you to the original creator, hope this remix is useful to someone else :)
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (13)