Corn On the Cob Holder
Print Profile(2)
Description
Hello!
During these hot summer days my kids and husband like corn on the cob more often than not. My husband carries the plates, and the corn usually rolls to the point where he holds it with his finger, so it doesn't roll off the plate. One day he said that he can't believe I haven't made something to stop that yet. I couldn't believe it either. So today I did.
Nothing fancy but it does do the trick. Saves it not only from rolling off the plate but also if you have someone that doesn't like their food to mix it holds it up by itself. Also holds the cob well for putting butter/salt or any toppings you prefer. (Please share if different toppings they like to try different ways)
There are some supports only at the ends as shown in one of my pictures. I was going to make the bottom flat stand longer to fit the top that the corn goes in but for some plates that may be too big to fit. I have this in PETG & PLA for whichever one you want to print. If you want it longer or shorter it will size well. This one is slightly over 2" wide and almost 5" long (about 50.8mm by almost 127mm).
Thank you so much for looking. Hope you have a wonderful day. Enjoy & Happy Printing!
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (2)