Commander Bly X Dummy 13

In this model you will find Commander Bly in his Dummy 13 form. (filaments used listed in the BOM below)

I hope this model brings you as much satisfaction as it did for me.

There are three notable features in this model: 

1. Removeable Pauldron piece
2. Adjustable Night vision Visors
3. Dc-17 holsters (blaster removeable
4. Chest Belt and Pouches 

Assembly: 

Assembly guide for the standard clone trooper is attached as a pdf. Assembly for the kama/s, pauldron, and visor, below. 

For the kama, there are two assembly options:

1. Print the kama and waist as two separate pieces and assemble them as follows (the following pictures are from my v1 kama but assembly order is identical) 

          2. Print the kama and waist as one pieces and skip to picture 3 of the instructions above.

Assembly for the chest belt and pouches can be found in this unlisted YouTube video.

The knots used is pictured below. 

The rubber bands you will NEED can be found here 

Finally, for the visor align the left visor knub to the left helmet hole and squeeze it in. Repeat on the other side. Please be gentle during this process. 

Removing Supports: Use the tools pictured below to aid in support removal 

If you want to print any weapons for your clone trooper, I am linking some good models below you can check out! 

This is a remix of the classic dummy 13 action figure. 

Check out the original Dummy 13 Action Figure by Lucky 13 Toys licensed under CC BY 4.0:

Dummy 13 - version 1.0! by Lucky 13 Toys MakerWorld: Download Free 3D Models

The Dc-17 blaster comes from the following model below by @irony

How I made this model: 

For the kamas, I remixed the arf trooper kama made by JackTheTinkerer here 

For the pauldron I remixed the pauldron made by FigureWorks here 

The visor is custom and the helmet is a remix of my clone helmet model here

The armor is a remix of my clone armor here