Mosquito Repellant Holder - Free 3D Print Model

Search models, users, collections, and posts

briansid

Hobby & DIY>Sport & Outdoors

IP Report

Print Profile(1)

All

X1 Carbon

P1S

A1 mini

H2D

P1P

X1E

H2D Pro

H2S

P2S

H2C

X2D

A2L

0.12mm layer, 2 walls, 15% infill

Designer

6.1 h

1 plate

4.0(1)

Open in Bambu Studio

Boost

Released

Description

This is a refill holder for the Thermcell Mosquito Repellant devices. It can hold the refills for the rechargeable outdoor devices. LEaving them out on their side can cause leaks, leaving stains and losing precious repellant. Leaving them upright out of the device when not in use saves repellant and keeps it fresh, and ready for use. This holder can support up to 5 refills.

I keep it out on my patio so they're ready to go at anytime.

It measures 110mm x 72mm x 43mm (LxWxH).

Comment & Rating (2)

@limecraft

Print Profile

0.12mm layer, 2 walls, 15% infill

I was puzzled by the orientation of the part in this profile but I guess I got schooled on how to print this. it came out great. The lay orientation means no supports needed and it came out perfect. This is 100% usable and works as intended but I would like a taller version so that the taller refills fit into the holder better, and spacing between refils could be larger so that they can fit better. I am still using it as it 100% works.

The profile uploader has replied

@briansid

Thanks for the feedback! I'm still very new to all of this and learning. I'll check the sizing again, because I thought I had updated that. Thanks for printing it and providing your feedback!

No more