ESP32-WROOM-32E Devkit Minimalist Casing

This casing was designed with minimalism in mind. I needed just for the contacts to be protected, but still allow for soldered wires to be connected to the ESP32. This is also with the assumption that the ESP32E is without the soldered pins.

The print should allow for the ESP32 to slip in nicely and stay in place. If it is either too tight or loose, just because the ESP32 PCB might come with some variations in dimensions from production, just warm the print up with some hot air or a flame and the 1mm walls should be easy to reshape slightly by hand for a nicer fit.