Search models, users, collections, and posts
Rolling Pool Cue Bridge
IP Report
Print Profile(1)
0.12mm layer, 2 walls, 15% infill
Designer
1.2 h
2 plates
Open in Bambu Studio
Boost
38
68
9
1
95
48
Released
Description
ASSEMBLY INSTRUCTIONS:
- Print the main body in TPU
- Print the Wheels in PLA (using a sharp tool, the supports should come out of the wheel pretty easily)
- Cut the steel rod (linked below) into 2" pieces
- Use the locking washers (also linked below) to connect the wheels onto the body. (I tend to print an extra wheel, and use it to hold the washer, allowing me to just tap the rod into it without losing the small washer pieces. It also stops the rod from going too far through the washer)
NEEDED EXTRAS:
https://amzn.to/3I2uO1W (Steel rods)
https://amzn.to/3I0v7dp (Locking washers)
Boost Me (for free)
License
This user content is licensed under a Standard Digital File License.
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (9)