Bookend of Satoru Gojo | Jujutsu Kaisen

Love this design? 💖

If you enjoy this aesthetic, please consider supporting my new project, KamiMarks!

While this design looks good here, if you want a printed one (that looks much better), you can find them at KamiMarks. 

And it's not just bookends! You'll also find bookmarks, book trackers, and more accessories for your manga, books, and shelves!

Bookend of Satoru Gojo | Jujutsu Kaisen Fan Art 👹

Figure, base to the right and base to the left are included.

• Figure thickness: 3 mm.
• Measurements (figure+base): 180 x 142 x 81 millimeters.
• Weight: ±120 grams.

It can be printed without AMS by adding the breaks in the layers exposed below and changing the filament, although it is easier using the AMS.

It can be printed with a 0.4 mm noozle. Actually, the files are optimized for 0,4 mm noozles.

Four colors are needed for the figure: black, dark gray, silver/light gray and white. I recommend printing the base in black.

The figure fits in the slot of the base and has to be glued. There are two versions:

• Right: this is the default location and is the one you have to use if you are going to put the bookend to the right of the books.
• Left: use it to place the bookend to the left of the books. Important: remember to mirror the figure on your slicer before printing it!

💡 Where are the bases? You can download the STL files of the bases from this page using the green "Download STL files" button. Alternatively, they're available as a separate download at this link.

To glue the figure to the base I recommend a transparent glue such as Bostik 820 and avoid Loctite / Super Glue, as it can cause white stains as a result of the glue curing in humid environments.

To improve adhesion, I recommend adding four silicone tears to the bottom of the base, as shown in the photos. You can find them at any DIY or stationery store.

Print made and verified using Recyled PLA from Smart Materials:
- Black
- Dark gray
- Silver
- White

Can I sell this bookends? ⛔

No, you cannot. 

Recommended print settings 🖨️

• Perimeter generator: Arachne
• Layer height: 0,2 mm
• Perimeters loops: 1
• Top layers: 1
• Bottom layers: 1
• Top layer pattern: Monotonic
• Bottom layer pattern: Monotonic
• Infill Density: 100%
• Infill pattern: Rectilinear
• Solid inner infill pattern: Monotonic
• Platform Adhesion: None
• First Layer: 50 mm/s
• First layer infill: 105 mm/s
• Outer perimeter: 200 mm/s
• Inner perimeter: 300 mm/s
• Low dense infill: 270 mm/s
• Inner solid infill: 250 mm/s
• Top solid infill: 60 mm/s (this one is key!)

For the base, use your default configuration for solids with a 15% infill. I recommend using cross-hatch or gyroid and slow down the speed in order to avoid any problem in the upper layers.

Colour swaps 🎨

• Start with black
• At layer 10 (2 mm) swap to dark grey.
• At layer 11 (2,2 mm) swap to grey/silver.
• At layer 13 (2,6 mm) swap to white for the rest.