Lima Bogie H0

I've made this h0 scale bogie of a Lima wagon by request on a Reddit.

3 type of connection - NEM socket, Hole and Hook.

Prints easily with 0.4 mm nozzle but 0.2 mm nozzle may be used for finer details. Assemble does not require any glue!

Steps to assemble:

1. Choose desired connector type: NEM socket (Blue), Hook (Teal) or Hole (Green). Use a piece of 1.75 mm filament to secure it inside of a hole on a Main Body (Red) of a bogie. Use cutters to remove excess filament.
2. Guide one of Sides (Gray) into Main body and make end part of a Main body click into a Side at the corners.
3. Install Bogie on your wagon using a Clip (White) or M3 screw.
4. Install Springs part (Yellow) to cover screw hole in Main body.
5. Install second Side. 

6. Add a pair of axles (11.2 mm wheel diameter max). To ease installation - slighlty lift end part of a main body holding side at the corner.