Mario Yellow Question Mark Drawer Box Brick IKEA Skadis Hanger

Recently received filaments in different colors, my wifi wants to print a set of Ikeda’s Mario Skadis hanger design, but after looking around, she found that there were no drawers, only pen holders, she said that it’s not very practical to only have pen holders, and that it would be better if there were drawers on which she could place decorations, I searched and found that there weren’t any, so there was nothing I could do, but to make my own.

Both drawers are quite simple, with minimal supports, and only require glue for assembly.

However, please note:

1, The question marks and dots on the sides of the yellow question mark drawer are thinner than those on the front, and are less prominent when attached to the box. This is a compromise to allow the two boxes to be closely aligned. If you do not need the two boxes to be closely aligned, you can print the question marks and dots on all three sides with the same prominence as the front. Apart from the difference in height, all other dimensions are identical.

2, The inner drawers of the yellow question mark drawer and the brick drawer are not interchangeable, please distinguish them.

Then, as a side note, after designing the brick drawer, I discovered that the brick pattern size I designed was different from that of Ikeda’s design. This was awkward, so being a severe perfectionist, I gritted my teeth and redesigned the other brick shelves, based on my own dimensions. These are included here, but they are not the main focus of this work, and are only provided to satisfy the needs of perfectionists. For ordinary users, I would still recommend that you download the original from the creator.