ESR - Brodit - Ball Joint

I use an ESR MagSafe car charger in my car. I discarded the included clamp because I already have a Brodit holder frame installed in my car.

If the nut on the charger is not defective, it is sufficient to print the ball plate. The ball plate is stiffened by a cylinder screw with a nut.

Recently, the nut broke, so I designed a new clamp that works with a clamping screw.

All parts are printed in BambuLab ABS.

Screws required:

• Ball plate: 1x DIN912 M3x16 and 1x DIN985 M3
• Clamp: 1x DIN933 M3x25 and 1x RUTHEX M3x5.7 insert nut