Search models, users, collections, and posts
Plunger for Virtual Pinball
IP Report
Print Profile(2)
0.2mm layer, 3 walls, 25% infill
Designer
2.4 h
1 plate
0.4mm layer, 3 walls, 25% infill
1.9 h
1 plate
Open in Bambu Studio
Boost
24
37
7
7
66
33
Released
Description
Most models I've found usually uses real pinball parts, which can be a hard to source and are not exactly cheap parts.
I designed this model around an ~11$ plunger easily found on AliExpress: Link
And this cheap ~3$ sliding potentiometer: Link
Supports are required, due to floating overhangs.
The round washer that came with the plunger is inserted into the hole in the base. This is to provide a nice large metal surface for the nut to press against.
It held pretty well, even without using the two screw holes.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (7)