Search models, users, collections, and posts
Windsurfer (Male and Female) - Wall / Desk Decor
Print Profile(2)
0.2mm layer, 3 walls, 20% gyroid infill
Designer
4.9 h
5 plates
For A1 Mini - 0.2mm layer, 3 walls, 15% gyroid infill
Designer
3.8 h
5 plates
Open in Bambu Studio
Boost
76
181
39
5
250
174
Released
Description
This 2D model of a windsurfer (a male and female version are available) can be used in two ways:
- Wall - Hang it on the wall with a simple nail or double-sided tape;
- Desk / Table - Put it on a desk, table or any other flat surface by using the stand.
No need for glue, the windsurfer will stay upright on the stand by itself. The stand can be printed as follows:
- Just flat, the waves will come out less nice though;
- With the use of PETG as support-interface for ‘normal’ supports - no aftercare or sanding needed;
- With ‘tree’ supports from the same type of filament - there is a possibility it'll need some aftercare or a little sanding to make the windsurfer fit.
Boost Me (for free)
The fact that you're looking at a model i made is already a huge compliment! If you could spare a boost that would really make my day!
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (39)