Search models, users, collections, and posts
Print Profile(1)
0.1mm layer, 3 walls, 100% infill
Designer
40 min
2 plates
Open in Bambu Studio
Boost
52
144
4
1
101
60
Released
Description
Sometimes these clips just break: this is a replacement. You need 2 identical pieces.
I printed them in PETG. Do not use brittle or soft filaments like PLA or PA; they need to be strong and stiff like ABS or PETG.
Use a quality profile with 0.1mm layers, 100% infill, or it could snap. Test it before use.
There are two version: one with integrated supports (works only with 0.1mm layers) and the other with auto supports. Print the one you prefer.
This is not the final iteration of my design, but it is good enough to be published. Feel free to leave suggestions.
License
This user content is licensed under a
Creative Commons Attribution
Comment & Rating (4)