3 Jaw Chuck for Drill

I loved the design by bobwomble over on Thingiverse for this attachment to turn your drill into a small lathe. I made a few modifications like joining the scroll and gear ring together, adding knobs to the drive gear because the hex hole would strip out easily, and beefing up the rear housing and making it fit a 8mm nut. I have also included MrArrow1961's reverse jaws so everything is in one place
 

There is even an assembly video by yuri9999 (this is with the original parts not my modifications but should be useful)

Hardware Needed:

3) M4 30-40mm long to lock the drive gears in place

3-6) M4 20-30mm to attach the back plate to the main housing