Search models, users, collections, and posts
PWM Speed Controller Enclosure
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
36 min
1 plate
Open in Bambu Studio
Boost
9
17
1
0
18
5
Released
Description
Content has been automatically translated.
PWM speed controller enclosure, controller dimensions 22*20*14.5 (L*W*H)
This PWM speed controller enclosure requires only 11g of filament and has a print time of 36 minutes
Boost Me (for free)
Thank you for your support
Assembly of the PWM speed controller enclosure requires four M3 screws (no nuts needed), 13.5mm in length (including screw head) The enclosure is a two-piece design, with an 18mm screw hole length in the enclosure; screw length should ideally be between 13mm and 18mm, and the screw holes have a countersunk design
Screw Length:
Screw Width:
Nut Width:
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (1)