Search models, users, collections, and posts
Print Profile(3)
(MAX 20mm) Single Mount (Print 2x) - 2 Plates | 0.2mm
Designer
2.2 h
2 plates
(MAX 40mm) Single Mount (Print 2x) - 2 Plates | 0.2mm
Designer
2.3 h
2 plates
Arm extender, PETG 0.2mm layer, 2 walls
2.1 h
1 plate
Open in Bambu Studio
Boost
36
116
11
5
145
96
Released
Description
Adjustable Tablet Holder for Monitor Risers:
Allows you to mount iPads, drawing tablets, portable monitors, or anything else to a monitor riser or a desk shelf, while still having room underneath for keyboard cables, or anything else you need.
Usage:
- 2 Clamp Options - Compatable with 10~20mm thick shelf & 30~40mm shelfs (can make more if requested)
- Additional “Holder” Sizes - remodelled to 240mm, or an extender that adds to original parts to give a length of 280mm.
- The mount clamps to a monitor riser with a screw, can be turned by hand, or with flat blade screwdriver for it to be extra-secure.
- The tablet mount itself can be adjusted over a range of angles by removing & re-inserting the locking pin. (there could definetly be a better way to do this such that it has more adjustability - remix it if you would like to! )
I use this to mount my Huion Kamvas drawing tablet to my monitor riser so that it can easily be used as a second monitor, but also within reach to be drawn on when needed.
- If you have any questions, concerns, or issues - let me know!
Printing Guide (If not using included print profile):
Its *reccomended* that you print 2 of these to place either side of your tablet (as pictured) for most stability.
- The Design is NOT Print In Place - seperate all parts before printing.
- Will probably want to enable supports for the “Desk Mount” part if you print sideways.
- Brim reccomended for the “locking pin”.
- The “Tablet Holder” parthas pre-made supports built in for the gap where it connects to the desk mount, make sure you have “detect thin walls” enabled.
Remixing/Alternate Versions:
- Remixing is allowed & encouraged :D - but be creative! some ideas:
- Adjusting the clamping mechanism to be more robust.
- Changing mount to accomodate thicker clamp surfaces.
- Redesigning the angle adjustment mechanism.
- Adjusting the tablet holder part to accomodate for more devices
- Thread size used for clamping screw is M10 x 1.5.
- I can share CAD files for parts if requested, but do not re-upload these seperately or on any other sites.
- For small adjustments, I can also remodel these and add a new print profile :)
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (11)