Nezuko Hueforge - Demon Slayer

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.2mm

The Model is 111.96x200mm in size
You may print at higher layer heights below the Base Thickness of 0.6mm
The Max allowed Thickness is 2.36mm and the Actual Thickness is 2.35997mm

Filaments Used:
    #000000 PLA BambuLab Matte Charcoal  Transmission Distance: 0.6
    #cd007b PLA BambuLab Basic Magenta  Transmission Distance: 3
    #e7ceb5 PLA BambuLab Basic Beige  Transmission Distance: 8
    #ffffff PLA BambuLab Basic Jade White  Transmission Distance: 5
This print uses 4 unique filaments

Swap Instructions:
    Start with Charcoal
    At layer #8 (0.76mm) swap to Magenta
    At layer #12 (1.08mm) swap to Beige
    At layer #18 (1.56mm) swap to Magenta
    At layer #20 (1.72mm) swap to Jade White for the rest.