Search models, users, collections, and posts
Xiaoniu U1 Turn Signal Bracket (Short Version)
Remixed by
IP Report
Print Profile(4)
0.24mm layer, 3 walls, 5% infill
Designer
2 h
1 plate
0.24mm layer, 2 walls, 15% infill
Designer
2 h
1 plate
Main body PETG (PLA support), base TPU for AMS
Designer
2.4 h
1 plate
Main body PLA (PETG support), base TPU for AMS
Designer
2.1 h
1 plate
Open in Bambu Studio
Boost
0
0
0
0
1
0
Released
Description
Content has been automatically translated.
The original long bracket wobbled too much, so I made a short version that's been tested in practice and hardly wobbles at all.
The bracket body is made of PLA or PETG, and the base is made of TPU for AMS (TPU with a hardness ending in D).
The bottom screws can be installed or not (if you use 64D TPU, it can be held in place without them).
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)