1st Gen Dodge Frame rail line holder

I recreated the frame rail fuel, brake and electrical wire loom holder from the 1st Gen dodge truck series. These were seen on trucks from the late 70s to early 90s. The original design had the line holder with a push pin style clip that would wear down over time. This rendition utilizes a stainless steel bolt (size M6 OR use a M6-1.00 nut and you'll need a bolt about 1 ¾" long/45mm) that goes through the center and can be removed and reinstalled multiple times. I used a lock nut to ensure stability. I printed these in 100% infill, and with ASA after pre heating my chamber for 20 minutes. 

Do NOT remove the negative modifier that I added, the first few prints has those small tabs not printed fully, even with thin walls detected on. I haven't gone back to F360 to fix it so this was the quickest fix.