Spaceballs: The Schwartz Ring - Upside Edition

Prepare 3D printer for ludicrous speed! Fasten all PTFE tubes, seal all nozzles and poop baskets, close all the slicers on your computer, cancel the four spool AMS, secure all filament in the zoo!

Warning: There is high probability that your 3D printer will lose the bleeps, will lose the sweeps, and will lose the creeps if you print this model. Please check Mr. Radar to ensure that you're 3D printer has not been jammed. For best results, do not use raspberry colored filament.

Now you can be the keeper of a greater magic, a power known throughout the universe... as the...
...the Force?
No, the Schwartz!

Fresh from a box of Cracker Jacks, now you can have your very own upside to the Schwartz.  Be the coolest nerd at the midnight showing of Spaceballs 2: The Search for More Money!

To avoid the need for supports, this prints in two parts.  One part is the large S, and the other is the actual ring.  There is an indentation in the bottom of the S that you can use to place the ring on it, either super glue or you can do what I did and weld them together with a soldering iron.  You won't see the ugly welds as it will be hidden by your finger when you wear it.

I see your Schwartz is as big as mine!

As this is a ring, I've included models for 21 different sizes, everything from size 4 to size 14, both whole and half sizes.  To figure out your size, wrap a string or piece of paper around your finger, then measure how long it is and match it up with the circumference on the below chart.  Remember to account for your knuckles.

This is not official Spaceballs moichandising and is not licensed Cracker Jacks or Yoghurt, it is simply fan art, please do not sell copies of it.

May the Schwartz be with you!