Search models, users, collections, and posts
TP Link Omada EAP225 EAP110 Outdoor Antenna Holder
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
1.8 h
1 plate
Open in Bambu Studio
Boost
5
10
0
1
9
4
Released
Description
Fed up with birds landing on my wifi antenna, and changing the orientation, I made this plate. It slides over the antennas (no need to remove them, just set them in the upward position), and then angle them in the position you want, and use cable ties to fix the position. It only works in a single plane. I tested it with the TP Link EAP225 Outdoor, but it should also fit the EAP110 model.
On top I have some teeth, to hopefully keep the birds from landing here.
Print it with any UV resistant material (I used ASA).
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (0)