Search models, users, collections, and posts
The Screen Thing - Make Your DM Screen Stand Up Perfectly!
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
20 min
1 plate
Open in Bambu Studio
Boost
84
323
20
9
287
188
Released
Description
WHAT IS IT?
I don't know what to call it, that's why it's called “The Screen Thing!” It's a little bracket that holds your DM screen at a perfect angle so it can't flop around. Print enough of these to fit all the bends in your DM screen, slip them on, and your table will look a lot neater!
There's a 2.5mm gap for the screen to snugly fit inside. If your screen is significantly thicker or thinner than that, I suggest you scale this model in your slicer!
NO ADDITIONAL HARDWARE NEEDED
MY PRINT SETTINGS
This little guy can be printed just about however you like. I printed mine at 20% infill at 3 walls. If your screen is super thick or super thin, you may want to scale the model up or down in your slicer.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (20)