Print Profile(0)
Description
Had old holes and bad paint around my door handle after replacing them, so I made this cover plate to hide the mess.
Use double-sided tape to stick it on — super easy and effective.
When customising, make sure to leave about 0.5mm tolerance, otherwise it might be too tight and hard to fit.
I recommend that you make all sides symetrical, to make this look very good and leave some mms near the door latch.
Mobile user? Can't print?
Leave a comment down below with the dimensions required (every detail given that is needed in OPENSCAD) and I will upload that model as a print profile for you!
Make sure to leave a photo afterwards!
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (0)